Sony MVS-8000X System - Page 1033

Chapter 20 Switcher Setup (Switcher)
1033
Signal Input Settings (Input Menu)
2 Adjust the following parameter.
To return the letterbox image to the center
In the <Letter Box Position> group, press [Center].
Making enhancer settings
1 In the Switcher >Input >FC Adjust menu, press [Enhancer], turning it on.
2 Set the following parameters.
Parameter group [1/2]
Parameter group [2/2]
Knob Parameter Adjustment Setting format Setting values
2 LB Position Image position 1080i/59.94 –31 to +32
1080i/50 –36 to + 36
720P/59.94,
720P/50
–30 to +30
Knob Parameter Adjustment Setting values
2 Detail Gain Adjust the edge
enhancement
sharpness
0 to 127
3 Limiter Adjust the
maximum signal
level to be added
to the original
signal
0 to 63
4 Crisp Set the amplitude
value for which a
low-amplitude
signal is not
emphasized
0 to 15
5 Level Depend Set the luminance
range for edge
enhancement
0 to 15
Knob Parameter Adjustment Setting values
2 Frequency Set the central
frequency for edge
enhancement
0 to 3
3 H/V Ratio Set the horizontal/
vertical ratio for
edge
enhancement
0 to 7