Chapter 4 Keys
182
Key Setting Operations Using Menus
Notes
In the emboss function it is not possible to set [Fine Key] on.
• When the edge type is normal, drop border or shadow, enabling the [Fine
Key] function keeps [Key Drop] on.
• When applying a border to the key edge, enabling the [Fine Key]
function halves the border width setting range.
To fix key fill and key source in key drop off mode
1
In the Edge menu, press [Key Delay Mode].
The Key Delay Mode menu appears.
2
Press [Frame Delay], setting it to On.
Notes
This function uses the resizer, and therefore the expected result of the
setting may not be obtained if conditions do not allow the resizer to be
used.
Carrying out a color mix for the key edge fill matte
When you select ‘Matte’ for the edge fill of a border, drop border, or shadow,
you can create a combination of color 1 and color 2 using a wipe pattern
generated by the dedicated pattern generator.
1
In the <Edge Fill> group of the Edge menu, select [Matte], then press
[Matte Adjust].
The edge fill Matte Adjust menu appears.
2
In the <Edge Matte> group, select [Mix Color], turning it on.
4 Bottom Key bottom edge position –2.00 to +2.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 H Phase Key horizontal position Left edge position
value shown
2 V Phase Key vertical position Top edge position
value shown
To Next Page
Loading...
