Sony MVS-8000X System - Page 524

Chapter 11 DME Operations
524
DME Special Effect Operations
2 Set the following parameters.
a) The Soft parameter is valid only when [Internal] is selected in the <Flex Shadow Source>
group.
Setting the center point of the flex shadow
1 In the Flex Shadow menu, press [Axis Loc], turning it on.
2 Adjust the following parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
•4:3 mode
• 16:9 mode
Knob Parameter Adjustment Setting values
1 Size H Enlarge or shrink horizontally 0.00 to 2.00
2 Size V Enlarge or shrink vertically 0.00 to 2.00
3 Size All Enlarge or shrink horizontally and
vertically
Value of Size H
shown
4
Soft
a)
Softness of shadow 0.00 to 100.00
5 Density Density of shadow 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Axis Loc H Move the shadow center axis
horizontally
–8.00 to +8.00 (SD)
–24.00 to +24.00 (HD)
2 Axis Loc V Move the shadow center axis
vertically
–6.00 to +6.00 (SD)
–18.00 to +18.00 (HD)
Knob Parameter Adjustment Setting values
1 Axis Loc H Move the shadow center axis
horizontally
–8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
2 Axis Loc V Move the shadow center axis
vertically
–4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)