Chapter 11 DME Operations
532
DME Special Effect Operations
Replicating the wipe crop pattern (Multiplication)
1
In the Wipe Crop menu, press [Multi], turning it on.
2
Set the following parameters.
a) See the following figure.
Modifying the wipe crop pattern edge
You can apply a border to the wipe crop pattern, or soften the boundary.
1
In the <Edge> group of the Wipe Crop menu, select one of the following.
Border: border
Soft: soft edge
Soft Border: soft border
2
Depending on the selection in step 1, set the following parameters.
• When Border is selected
2 Frequency Frequency of modulation 0.00 to 100.00
3 Speed Speed of waves –100.00 to +100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 H Multi Number of repetitions of
pattern horizontally
1 to 63
2 V Multi Number of repetitions of
pattern vertically
1 to 63
3 Invert Type Replication layout
1 to 4
a)
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00
To Next Page
Loading...
