Sony MVS-8000X System - Page 556

Chapter 11 DME Operations
556
DME Special Effect Operations
To stop the waves
Press [Lock], turning it on.
With each press, the waves alternately stop and start moving again.
To select the waveform
Press [Form] and set the following parameters.
• When H&V mode is selected
• When Size mode is selected
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabola wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic wave
To randomize the modulated waveform
1 Press [Random], turning it on.
2 Set the following parameters.
• When H&V mode is selected
• When Size mode is selected
Knob Parameter Adjustment Setting values
1 Form H Waveform in horizontal direction
1 to 6
a)
2 Form V Waveform in vertical direction
1 to 6
a)
Knob Parameter Adjustment Setting values
1 Form H Waveform
1 to 6
a)
Knob Parameter Adjustment Setting values
1 Random H Degree of randomness in
horizontal waveform modulation
0.00 to 100.00
2 Random V Degree of randomness in vertical
waveform modulation
0.00 to 100.00
3 Random All Degree of randomness in both
vertical and horizontal directions
Random H value
shown
Knob Parameter Adjustment Setting values
1 Random H Degree of randomness in
waveform modulation
0.00 to 100.00