Chapter 11 DME Operations
564
DME Special Effect Operations
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
To reverse the ripple range
When modulation mode is Radial, Both, or Shape: Press [Range Rev R],
turning it on.
When modulation mode is Both or Angular: Press [Range Rev A], turning
it on.
Other settings
You can turn [Lock], [Form], [Random], and [Range Envelope] on to do the
following.
• Stop the waves
• Select the wave shape
• Randomize the waveform
• Smooth the range envelope when the wave range is limited
For Lock, Form, Random, and Range Envelope functions, see “Wave settings”
(page 553).
Rings settings
You can set the degree of transition, the degree of randomness in the distance
moved by each block, the amount of movement, the width of the partitions, the
degree of randomness in partition width, the center point, the starting angle,
and other parameters.
To apply the Rings effect
With the Rings menu displayed, use the following procedure.
1
To make transition settings, press [Transition] and set the following
parameters.
3 Size A Amount of ripple modulation
along periphery
0.00 to 100.00
4 Offset A Center of modulation range
along periphery
–8.000 to +8.000
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.000 to 100.000
2 Random Degree of randomness in distance
moved by each block
0.000 to 100.000
3 Spiral Amount of movement toward
periphery accompanying transition
–1.000 to +1.000
To Next Page
Loading...
