Chapter 11 DME Operations
578
DME Special Effect Operations
To apply the Explosion effect
With the Explosion menu displayed, use the following procedure.
1
In the <Mode> group, select the explosion pattern.
•Circle
• Rectangle
•Star
• Heart
• Ellipse
2
Set the following parameters.
• When Circle was selected in step 1
• When Rectangle, Star, Heart, or Ellipse was selected in step 1
To make the fragments stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
To set the explosion center point
1
Press [Position], turning it on.
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.00 to 100.00
2 Curve Degree to which image periphery
expands
0.00 to 100.00
3 Spiral Degree of curvature of transition
path
–100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.00 to 100.00
2 Curve Degree to which image periphery
expands
0.00 to 100.00
3 Aspect Aspect ratio of waveform –100.00 to +100.00
4 Angle Slant of waveform –8.000 to +8.000
Knob Parameter Adjustment Setting values
1 Density Degree to which image
disappears
0.00 to 100.00
2 Random Degree of randomness in flying
out fragment positions
0.00 to 100.00
To Next Page
Loading...
