Chapter 11 DME Operations
609
DME Special Effect Operations
Notes
• The BZDM-9050 Texture Lighting Software (for MVE-9000) is
required to enable Texture or Non Linear.
An install key must be entered to use the software (For details, see
“Installation and Device Setup (Install/Unit Config Menu)” in Chapter
18 (Volume 3).)
• The Spotlighting Non Linear setting is effective for the following
nonlinear effects. For any other nonlinear effect, the result of selecting
the Non Linear setting is the same as selecting Flat.
Wave, Mosaic Glass, Flag, Ripple, Lens, Panorama, Page Turn, Roll.
5
If you selected Texture or Non Linear in step 4, set the following
parameters.
Parameters when you selected Texture
•SD format
a) Minus moves left, plus moves right.
b) Minus moves down, plus moves up.
c) Plus emphasizes bumps in texture, minus emphasizes depressions. 0.00 is a flat surface.
•HD format
a) Minus moves left, plus moves right.
b) Minus moves down, plus moves up.
c) Plus emphasizes bumps in texture, minus emphasizes depressions. 0.00 is a flat surface.
Parameters when you selected Non Linear
Knob Parameter Adjustment Setting values
1 X Movement in X-axis direction
–8.00 to +8.00
a)
2 Y Movement in Y-axis direction
–6.00 to +6.00
b)
3 Size X Image size in X-axis direction 0.50 to 16.00
4 Size Y Image size in Y-axis direction 0.50 to 16.00
5 Amp Emphasize bumps and
depressions
–100.00 to +100.00
c)
Knob Parameter Adjustment Setting values
1 X Movement in X-axis direction
–32.00 to +32.00
a)
2 Y Movement in Y-axis direction
–24.00 to +24.00
b)
3 Size X Image size in X-axis direction 0.50 to 16.00
4 Size Y Image size in Y-axis direction 0.50 to 16.00
5 Amp Emphasize bumps and
depressions
–100.00 to +100.00
c)
Knob Parameter Adjustment Setting values
5 Amp Distance of light
–100.00 to +100.00
a)
To Next Page
Loading...
