Chapter 19 Control Panel Setup (Panel)
951
Overall Control Panel Settings (Config Menu)
Assigning a Region to a Region Selection Button in the
Numeric Keypad Control Block
A maximum of four regions can be set for a single region selection button in
the numeric keypad control block.
1
In the Panel >Config menu, press [10 Key Region Assign].
The 10 Key Region Assign menu appears.
The left side of the status area shows region selection buttons; the upper
part of the right side shows a list of regions assigned to region selection
buttons, and the lower part shows a list of assignable regions.
2
Press the indication of the button for the assignment.
The button you pressed appears in reverse video.
3
Using any of the following methods, select one of the four regions for the
setting.
• Press directly on the list in the upper part of the right side.
• Press the arrow keys to scroll the reverse video cursor in the list in the
upper part of the right side.
• Turn the knob.
To Next Page
Loading...
