Chapter 19 Control Panel Setup (Panel)
952
Overall Control Panel Settings (Config Menu)
4
Using any of the following methods, select the region to be assigned.
• Press directly on the list in the lower part of the right side.
• Press the arrow keys to scroll the reverse video cursor in the list in the
lower part of the right side.
• Turn the knob.
5
Press [Set], to confirm the selection.
This assigns the region to the region selection button in the numeric
keypad control block.
Notes
Only regions assigned here can be used for keyframe or snapshot recall.
To return the region assignment to the factory default state
In the Panel >Config >10 Key Region Assign menu, press [Default].
This returns the assignment of region selection buttons in the numeric keypad
control block to the factory default state.
To delete a region assignment
In step 3 of the procedure “Assigning a Region to a Region Selection Button
in the Numeric Keypad Control Block” (page 951), make the selection to
which the operation applies, then press [Clear].
This clears the assignment of the selected region.
Setting the region selection buttons selected when the [ALL]
button is pressed
1
In the Panel >Config >10 Key Region Assign menu, press [All Select] in
the button area, or the [All Select] button indication in the status area,
setting it to On.
The [All Select] button indication in the status area changes to orange, and
the system switches to a mode for assigning region selection buttons to the
[ALL] button. In the factory default state, all buttons appear in reverse
video, and are assigned to the [ALL] button.
Knob Parameter Adjustment Setting values
1 Button Assign Selection to which setting
applies
1 to 4
Knob Parameter Adjustment Setting values
2 Region Region selection 1 and upwards
To Next Page
Loading...
