Chapter 19 Control Panel Setup (Panel)
970
Cross-Point Settings (Xpt Assign Menu)
Notes
When a button number upper than 121 is selected, execution of “Insert” is
impossible. The signal assignments to button numbers upper than 121
cannot be changed. When “Insert” is executed for any other number,
moving down of signals ends at number 120, and the signals assigned to
numbers upper than 121 are maintained in their original lines.
To disable a button
In the Panel >Xpt Assign >Table Button Assign menu, select the button you
want to disable, and press [Inhibit].
To delete any currently assigned signal
In the Panel >Xpt Assign >Table Button Assign menu, select the button
corresponding to the signal you want to delete, and press [Delete] in the
<Button Assign> group.
The signal assigned to the button number next to the selected button number
and following signals move up one line.
Notes
When a button number upper than 121 is selected, execution of “Delete” is
impossible. The signal assignments to button numbers upper than 121 cannot
be changed. When a signal assigned to any other button number is deleted,
moving up of signals ends when the signal assigned to number 120 has moved
to number 119, and the signals assigned to numbers upper than 121 are
maintained in their original lines.
Returning the table to its default state
1
In the Panel >Xpt Assign >Main, V/K Pair Assign menu or Panel >Xpt
Assign >Table Button Assign menu, press [Default Recall].
A confirmation message appears, asking whether or not to return to the
default state.
2
To return to the default state, press [Yes], and to cancel the operation, press
[No].
Setting the cross-point button shift operation
You can set the operation of the rightmost button in each row of cross-point
buttons excluding the reentry buttons.
In the <Xpt Shift Mode> group of the Panel >Xpt Assign >Main, V/K Pair
Assign menu or Panel >Xpt Assign >Table Button Assign menu, select one of
the following for each cross-point table.
To Next Page
Loading...
