OnAir 2000M2 Digital Mixing Console
Date printed: 12.11.03 SW V 4.0 Operating Concept 3-5
CUT: If pressed, the monitor speakers are muted, and the CUT key is illumi-
nated. As long as one of the CR or DJ microphones is on, the monitor
speakers are automatically muted, and the CUT key is illuminated.
[3] PFL/TB PFL/TB: Volume control for the built-in PFL/TB speakers.
EXT PFL: The EXT PFL input can be used as an external PFL input to the monitor-
ing unit. If pressed, the key is illuminated, the external signal is routed to
the PFL bus, and the external PFL control output is active.
PFL>MON: If PFL is active on any channel, the PFL signal is routed to the main
monitor speakers. If no PFL is selected, the monitoring signal is the stereo
CR signal as selected. The PFL>MON key is illuminated if active.
[4] Headphones PHONES : Headphones volume control. The headphones socket (6.3 mm TRS jack) is
located below the hand rest of the central console part.
Three keys allow different monitoring modes:
PFL: PFL and TB signals are routed to the headphones.
MON/PFL: The left-channel headphones signal is the mono PFL signal, while the
right-channel headphones signal is the mono CR signal as selected by the
monitoring source selector [1]. If no PFL is selected, the headphones sig-
nal is the stereo CR signal as selected.
MON: The headphones signal is the same stereo signal as selected by the moni-
toring source selector [1]. It is, however, not affected by the DIM and CUT
functions.
[5] Talkback Selector for five talkback targets:
N–1 B/N–1 A: Connection between the DJ microphone* in the control room and the cor-
responding cleanfeed (N–1) output; this allows talking e.g. to the con-
nected telephone hybrid(s) or communication lines.
AUX 2/AUX 1: Connection between the DJ microphone* in the control room and the
AUX 2 or AUX 1 outputs.
STUDIO: Connection between the DJ microphone* in the control room and the stu-
dio speakers and headphones.
The built-in PFL/TB loudspeakers and/or the headphones are used for
talkback listening in the control room.
* If a console is equipped with an additional talkback microphone, this mi-
crophone is used instead of the DJ microphone.
[6] F1...F5 Programmable function keys, e.g. for additional CR monitor selector keys
(with optional Monitor Expander unit, refer to 12.2.11).
[7] Signaling Lamps ON-AIR Is turned on by a control signal on the “SIGN.” control connector on the
monitoring module.
CR-MIC Is on if at least one microphone in the control room is routed to the pro-
gram or to the record output (i.e. the corresponding output is selected, the
channel is ON, and the fader is opened).
STUDIO-MIC Is on if at least one microphone in the studio is routed to the program or to
the record output (i.e. the corresponding output is selected, the channel is
ON, and the fader is opened).
[8] Loudspeaker For PFL and talkback signals.
To Next Page
Loading...
Need help?
General
