OnAir 2000M2 Digital Mixing Console
Date printed: 12.11.03 SW V 4.0 General 2-1
2 GENERAL
2.1 Utilization for the Purpose Intended
The OnAir 2000M2 mixing console is intended for professional use.
It is presumed that the unit is operated only by trained personnel. Servicing
is reserved to skilled technicians.
The electrical connections may be connected only to the voltages and sig-
nals designated in this manual.
2.2 First Steps
2.2.1 Unpacking and Inspection
Your new mixing console is shipped in a special packing which protects
the units against mechanical shock during transit. Care should be exercised
when unpacking so that the surfaces do not get marred.
Verify that the content of the packing agrees with the items listed on the
enclosed shipping list.
Check the condition of the equipment for signs of shipping damage. If
there should be any complaints you should immediately notify the for-
warding agent and your nearest Studer distributor.
Please retain the original packing material because it offers the best pro-
tection in case your equipment ever needs to be transported.
2.2.2 Installation
Primary Voltage: The power supply unit is auto-ranging; it can be used for mains voltages in
a range of 100 to 240 V
AC
, 50 to 60 Hz.
General Precautions: Do not use the unit in conditions of excessive heat or cold, near any source
of moisture, in excessively humid environments, or in positions where it is
likely to be subjected to vibration or dust. The ambient temperature range
for normal operation of the unit is +5...+40° C.
Unobstructed air flow is essential for proper operation. The air vents at
the rear and the bottom of the unit are a functional part of the design and
must not be blocked in any way. Never remove the rubber feet of the unit
when placing it on a flat surface!
Cleaning: Do not use any liquids to clean the exterior of the unit. A soft, dry cloth or
brush will usually do.
For cleaning the touch-screen display windows, most of the commercially
available window or computer/TV screen cleaners are suited. Use only a
slightly damp (never wet) cloth. Never use any solvent!
Power Connection: The attached female IEC 320/C13 mains cable socket has to be connected
to an appropriate mains cable by a trained technician, respecting your local
regulations. Refer to the “Installation, Operation, and Waste Disposal”
section at the beginning of this manual.
To Next Page
Loading...
Need help?
General
