OnAir 2000M2 Digital Mixing Console
5-16 Master Functions SW V 4.0 Date printed: 12.11.03
5.8.4 Delete a Channel Routing from Memory (Administrator Only)
When saving a channel routing, the previously stored data are overwritten.
A global channel routing can be deleted, too, without overwriting it by
new data. To do this, first the desired channel routing has to be selected.
The selected field is highlighted. After touching the DELETE MEM field,
a dialog box will appear. If it is confirmed, the channel routing will be
permanently removed from the memory, and the text within the selected
field is cleared.
For more information on deleting global channel routings please refer to
chapter 5.10.2.
5.8.5 Channel Routing Administration
In addition to the user's own user channel routing, the administrator can
save the current channel routing to one of the five globally-accessible
channel routings. These can be recalled in the Mixer Setup page. The de-
fault and global channel routings can be saved or edited by the adminis-
trator; the default user's user routing can also be saved or edited by any
user not logged-in (i.e. the default user), if access permission is given.
Channel Routings:
User Channel Routing The procedure for the system administrator changing a user's channel
routing is described in chapter 5.10.2.
Global Channel Routings Five globally accessible channel routings can only be created by the ad-
ministrator, allowing users to set-up the channel routing for specific
transmissions, e.g. news broadcasts or sports events. Users do not have ac-
cess to the global channel routings configuration. However, access permis-
sion given, a user could load a global channel routing, edit it, and store it
in his own user profile.
Administrator Protection: The administrator can protect specific connections within the channel
routing by selecting the desired cross-point with the horizontal and vertical
lines, and then touching the PROT field. A protected connection is indi-
cated by a dashed vertical line in the grid (see below); this connection can-
not be changed by the users, even if they are allowed to change their chan-
nel routing. Only the administrator can UNPROT this connection again.
However, the user can change the input selection A/B (or A...F in case of a
hex input module) of this input module, if he has the INPUT SEL access
permission.
To Next Page
Loading...
Need help?
General
