OnAir 2000M2 Digital Mixing Console
10-4 Automation SW V 4.0 Date printed: 12.11.03
10.3.5 Indication of the Currently Playing Input Line
As the OnAir 2000M2 is not equipped with motor faders, a clear indicat-
ion of the channel currently “playing” is visible on the screen of the CAB
system.
Under the following conditions the selector field on the channel screen
indicates “ON-AIR” (refer to the figure above), and the selection of an-
other input is inhibited:
• The channel is switched ON;
• The channel is assigned to program and/or record bus (as defined in the
Common Settings page);
• The channel is selected by the CAB.
10.3.6 Pre-Listening
When starting the pre-listening function in the CAB system by clicking on
the LISTEN button on the CAB screen, followed by selecting a title, the
CAB system immediately sends the desired title over the fourth channel of
its audio card. At the same time, it opens the external PFL input, so that
the desired title is audible in the console's PFL loudspeakers.
10.3.7 Time Synchronization
The CAB is able to set the console's internal clock (time and date) if TIME
SYNC. is set to AUTOMATION in the TIME & DATE FORMAT page;
refer to chapter 12.2.5.
To Next Page
Loading...
Need help?
General
