OnAir 2000M2 Digital Mixing Console
12-8 Configuration SW V 4.0 Date printed: 12.11.03
If the OFF function is selected for the OFF key, the channel is switched off
by pressing this key; if LOCATE is selected, the ON function automati-
cally changes to a channel ON/OFF toggle function (also refer to chapters
9.2 and 9.3).
DEFAULT MASTER LEVEL: The level of the ΣPGM and ΣREC outputs can be biased in a range of
–7 to +5 dB using the two rotary encoders below the corresponding fields.
This setting is only valid if no fader strips are assigned to the ΣPGM
and/or ΣREC outputs; please note that this setting must be done with care,
as it directly affects the level of the main outputs.
Note: The MASTER FADER ASSIGNMENT function for PGM and REC out-
puts that was available on this page in earlier software versions is located
on the CHANNEL ROUTINGS page now; please refer to chapter 5.9.
12.2.3 Output
On the OUTPUT CONFIG. page, the types of the output signals on the
AUX 1, AUX 2, and AUDITION buses can be set.
12.2.4 Level Meter
The LEVEL METER configuration page defines the signal sources for the
level meters no. 1 and no. 2.
Available signal sources:
METER 1 SOURCE CR MONITOR, PROGRAM, RECORD, AUX 1, AUX 2, AUDIT,
N–1 A.
METER 2 SOURCE CR MONITOR, PROGRAM, RECORD, AUX 1, AUX 2.
To Next Page
Loading...
Need help?
General
