OnAir 2000M2 Digital Mixing Console
Date printed: 12.11.03 SW V 4.0 Configuration 12-17
12.2.12 Customer Code
Starting with software version 2.0.1, there is a possibility to activate op-
tional, customer-specific functions as, for instance, the hex source selector
fields on the touch-panel of the fader strip. For this purpose, a feature
called Customer Code is used. Please note that the customer codes are
displayed and entered in hexadecimal.
Code 0x00000000 Default Setting
Code 0x00000001 Permanent Hex Input Selection
For permanent display of the hex input selection field in the channel
screen, refer to chapter 4.4.1.
Code 0x00000002 High Shelving Filter Modification
When selected, the turnover frequency of the high-shelving filter is re-
duced by approx. one octave, resulting in increased filter effect. For more
information on EQ and filters, please refer to chapters 4.4.5 and 4.4.6.
Code 0x00000004 External CR DIM Function
The spare control input on the Monitoring Module (“SIGN.” connector P4,
9-pin D-type) can be used as CR DIM control input. If activated by an ex-
ternal control signal, the CR monitor speakers are attenuated by 20 dB.
Please refer to the pin assignment table and connection diagram in chapter
15.13.
Code 0x00000008 MONITORA: SAS_INPUTROUTING
Allows to ask for the SAS_INPUTROUTING, even if no SOURCE was
selected for that fader.
Code 0x00000010 MONITORA: SET_FADER_LEVEL
If the broadcast automation system sets a level (SET_FADER_LEVEL) to
0 dB and the current physical position of the corresponding fader is be-
tween +4.5 dB and –4.5 dB, then the channel’s level is set according to the
physical fader position instead of 0 dB.
This avoids the console to enter the Auto Takeover mode.
Note: Not implemented for the SET_FADER_LEVEL_ONLY command.
Code 0x00000020 Shift Studio TB to N–1
Allows talkback from the studio to the outputs N–1C and N–1D, instead of
to N–1A and N–1B.
Code 0x00000040 Longer Reverb Time
Increases the delay for the switching from CR Cut or CR Dim to
CHANNEL ON, or from CHANNEL OFF to CR UnCut or CR UnDim
from 40...50 ms to 160...170 ms.
This delay is used to avoid acoustical feedback noise from the CR monitor
speakers to a microphone channel being opened (CHANNEL ON), when
the control room has an unusually long reverb time.
Code 0x00000080 Faders 0 dB on Top
For applications where the 0 dB point of the faders is desired to be at the
fader's upper end position, this code can be used. It shifts the DSP gain
setting with respect to the mechanical fader position by –10 dB.
Code 0x00000100 Fader Start and Stop Pulse
When CTRL OUT1 mode is set to "ON & FADER" in the INPUT
CONFIG. page (refer to chapter 9.2), 200 ms pulses are generated instead
To Next Page
Loading...
Need help?
General
