OnAir 2000M2 Digital Mixing Console
4-2 Channel Functions SW V 4.0 Date printed: 12.11.03
4.4 Channel Screen
A channel screen is located above each group of six fader strips. The
channel screen has a touch matrix with 2 × 6 switch fields per fader strip
as shown below.
The channel screen always maintains system overview by displaying the
relevant settings of the six fader strips. When touching one of the switch-
ing fields, the central control screen automatically displays the attached
operating field and allows parameter entry. In the channel screen, the
status display is immediately updated.
In the following chapters we assume that the user has access permission to
all functions, unless otherwise noted. Access permission may be limited,
causing that certain screen parts are blank. For a description of how to set
up access permission, refer to chapter 11.
4.4.1 Channel Screen Fields
Input Selector Field: For microphone and analog/digital line input modules, the Input selector
field directly selects one of two physical input signals routed to this fader
strip. The field of the selected input is highlighted, and the source name
appears in the source label field. While the channel is active (i.e. channel
ON, fader opened and output selected), the input selection is disabled.
If a hex-input module is routed to this fader strip, the source selection can
be made in two different ways depending on the Customer Code setting
(for more information on Customer Codes, refer to chapter 12.2.12):
Code 0x00000001 inactive: When touching the input selector field, a Source Selector page appears on
the central control screen that allows selecting one of the six connected
sources. The input selector field displays the currently selected input of the
Input Selector Field
Input Field
EQ/Filter Field
AUX Field
PAN/BAL Field
Source Label Field
To Next Page
Loading...
Need help?
General
