Telit Wireless Solutions ME910G1 - AT#NIPDRECV - Retrieve Non-IP Data

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 1011 of 1039 2021-09-23
Not Subject to NDA
3.27.4. AT#NIPDRECV - Retrieve Non-IP Data
This command allows the TE to retrieve the received MT Non-IP data. It is supported by
modules with NBIoT technology.
When MT Non-IP data are received, an unsolicited message is reported in the format:
#NIPDSRING: <recvdLen>
To get the data use #NIPDRECV command.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#NIPDRECV=<readLen>[,<mode>]
Parameters:
Name
Type
Default
Description
<readLen>
integer
-
data length to be retrieved, see test
command to get the available data length
range.
If <readLen>=0 the information about
received data are queried, see Additional
info section.
<mode>
integer
0
data format
Values:
0
:
ASCII format string
1
:
HEX format string
Additional info:
<read_len>=0
The response reports the length of received data, read data and
unread data, in the format: