Telit Wireless Solutions ME910G1 - AT+CGCONTRDP - PDP Context Read Dynamic Parameters613

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 613 of 1039 2021-09-23
Not Subject to NDA
3.14.8. AT+CGCONTRDP - PDP Context Read Dynamic Parameters
The execution command returns the relevant information for a PDP Context established
by the network.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT+CGCONTRDP[=<cid>]
The execution command returns the relevant information on a PDP Context
established by the network with the context identifier <cid>. If the parameter
<cid> is omitted, the information for all established PDP contexts is returned.
The response message has the following format:
+CGCONTRDP:<cid>,<bearerId>,<apn>[,<ip&subnet>[,<gw_addr>[,<DNS_prim>
[,<DNS_sec>[, <P_CSCF_prim>[,<P_CSCF_sec>]]]]]][<CR><LF>
+CGCONTRDP:<cid>,<bearerId>,<apn>[,
<ip&subnet_mask>[,<gw_addr>[,<DNS_prim>
[,<DNS_sec>[, <P_CSCF_prim>[,<P_CSCF_sec>]]]]]] [...]]
If the context cannot be found an ERROR response is returned.
The response message parameters are described in the Additional info
section.
Parameter:
Name
Type
Default
Description
<cid>
integer
-
identifies a non secondary PDP context
definition. The parameter is local to the TE-
MT interface and is used in other PDP
context-related commands.
Additional info: