Telit Wireless Solutions ME910G1 - AT#SSENDUDP - Send UDP Data to a Specific Remote Host679

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 679 of 1039 2021-09-23
Not Subject to NDA
3.15.18. AT#SSENDUDP - Send UDP Data to a Specific Remote Host
This command allows to send data over UDP to a specific remote host.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#SSENDUDP=<connId>,<remoteIP>,<remotePort>[,<Rai>]
This command allows, while the module is in command mode, to send
data over UDP to a specific remote host. UDP connection has to be
previously completed with a first remote host through #SLUDP / #SA.
Then, if module receives data from this or another host, it is able to send
data to it. Like command #SSEND, the device responds with ">" prompt
and waits for the data to send.
Parameters:
Name
Type
Default
Description
<connId>
integer
1
socket connection identifier
Value:
1÷10
:
identifier number
<remoteIP>
string
-
IP address of the remote host in
dotted decimal notation, string
type: "xxx.xxx.xxx.xxx"
<remotePort>
integer
1
remote host port
Value:
1÷65535
:
host port number
<Rai>
integer
N/A
RAI (Release Assistance
Indication) configuration
Values:
1
:
Set RAI to: "No further uplink or downlink data
transmission subsequent to this transmission"