Telit Wireless Solutions ME910G1 - AT+IFC - DTE-Modem Local Flow Control

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 160 of 1039 2021-09-23
Not Subject to NDA
3.2.4.11. AT+IFC - DTE-Modem Local Flow Control
This set command selects the flow control of the serial port in both directions.
ITU-T Recommendation V25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+IFC=<byDTE>,<byDCE>
Parameters:
Name
Type
Default
Description
<byDTE>
integer
0
specifies the method used by the DTE to
control the flow of data received from the
device (DCE)
Values:
0
:
no flow control
2
:
flow control by RTS control line (C105, Request to
Send)
<byDCE>
integer
0
specifies the method used by the device
(DCE) to control the flow of data received
from the DTE
Values:
0
:
no flow control
2
:
flow control by CTS control line (C105, Clear to Send)
The only possible commands are AT+IFC=0,0 and AT+IFC=2,2.