Telit Wireless Solutions ME910G1 User Manual

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 863 of 1039 2021-09-23
Not Subject to NDA
3.23.5. AT+M2M - Enable/disable M2M Application execution
This command enable/disable the M2M Application execution start mode.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+M2M=<mode>[,<delay>]
Set command sets the M2M Application start mode. After issuing the AT
command, the module automatically restart.
Parameters:
Name
Type
Default
Description
<mode>
integer
1
M2M application execution start mode
Values:
0
:
AppZone engine does not start at the next reboot
1
:
AppZone engine starts at the next reboot without
delay. Only apps with AT#M2MRUN=1 will start after
reboot, with their specific delay setting.
4
:
AppZone engine starts at the next reboot using the
delay set by <delay> parameter, if missing is used the
default value 10.
<delay>
integer
0
M2M application execution start time-out
expressed in seconds.
Parameter <delay> is used only if
parameter <mode> is set to 4.
Values:
0
:
no delay for AppZone engine to start
10÷60
:
delay for AppZone engine to start. During this
waiting time an AT command on the serial/USB

Telit Wireless Solutions ME910G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ME910G1
Category	Wireless modules
Language	English