Telit Wireless Solutions ME910G1 - AT#V24 - V24 Output Pins Control

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 542 of 1039 2021-09-23
Not Subject to NDA
3.10.9. AT#V24 - V24 Output Pins Control
This command sets the state of the output pins of the AT commands serial port
interface.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#V24=<pin>[,<state>]
Set command sets the AT commands serial port interface output pins
state.
Parameters:
Name
Type
Default
Description
<pin>
integer
0
AT commands serial port interface
hardware pin:
Values:
0
:
DCD (Data Carrier Detect)
1
:
CTS (Clear To Send)
2
:
RI (Ring Indicator)
3
:
DSR (Data Set Ready)
<state>
integer
0
State of AT commands serial port interface
output hardware pins (0, 1, 2, 3) when pins
are in GPIO mode (see #V24CFG):
Values:
0
:
Low state
1
:
High state