Telit Wireless Solutions ME910G1 - Ipeasy; AT#SGACT - Context Activation

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 635 of 1039 2021-09-23
Not Subject to NDA
IPEasy
3.15.1. AT#SGACT - Context Activation
This command enables/disables the PDP context activation.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#SGACT=<cid>,<stat>[,<userId>[,<pwd>]]
Execution command is used to activate the specified PDP context, followed
by binding data application to the PS network. Also, it is used to deactivate
the PDP context and unbind data application from PS network.
Execution command returns a list of IP addresses for the specified context
identifiers in the format:
for IP or IPV6 PDP context: #SGACT: <ipAddr>
for DUAL STACK IPV4V6 PDP context: #SGACT: [<ipAddrV4>],[<ipAddrV6>]
Parameters:
Name
Type
Default
Description
<cid>
integer
-
specifies a particular PDP context
definition. To know the range see
+CGDCONT command.
<stat>
integer
0
activates/disactivates the PDP context
specified
Values:
0
:
deactivate the context
1
:
activate the context