Telit Wireless Solutions ME910G1 - AT#DGEN - Dying GASP Configuration

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 570 of 1039 2021-09-23
Not Subject to NDA
3.11.6. AT#DGEN - Dying GASP Configuration
This command enables/disables the Dying GASP configuration, configures a GPIO pin
to perform a specific behavior at dying gasp of module, can also be used to read the
last dying event.
[1] Hardware User's Guide of the used module
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#DGEN=<mode>[,<GPIO>,<Trigger>,<Action>,<URC>[,<text>,<text_format>[,<S
MS_Num>] [,<cid>,<IPProtocol>[,<IPAddr:Port>]]]]
Parameters:
Name
Type
Default
Description
<mode>
integer
0
enable/disable dying GASP behavior
or read report
Values:
0
:
disable dying GASP
1
:
set the command parameters
2
:
read dying GASP statistics
<GPIO>
integer
N/A
GPIO pin number. Max is the number
of GPIO pins provided by the module.
For information on the available GPIO
pins use the test command.
Value:
1÷Max
:
GPIO pin identifier
<Trigger>
integer
0
GPIO Trigger used for event