Telit Wireless Solutions ME910G1 - AT#CSURVC - Network Survey (Numeric Format)

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 583 of 1039 2021-09-23
Not Subject to NDA
3.12.2. AT#CSURVC - Network Survey (Numeric Format)
This command performs a survey on the selected band channels. The return message
uses only the numeric format.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#CSURVC[=[<s>,<e>]]
Execution command performs a quick survey on channels belonging to the band
selected by last #BND command issue, starting from channel <s> to channel <e>.
The information provided by this command is the same as that provided by
#CSURV command. The difference is that the output of #CSURV is in numeric
format only, the parameters names are not reported
Issuing AT#CSURC<CR>, a full band scan is performed. The command responds
with the following string:
Network survey started...
After a while, a list of network survey information text lines in numeric format,
one for each received carrier, is reported. The format of network survey
information text lines depends on technology (2G or 4G) and BCCH (BCCH-Carrier
or non BCCH-Carrier).
The #CSURVC output ends in two ways, depending on the last #CSURVF setting.
If AT#CSURVF=0 or AT#CSURVF=1 the output will end with the string:
43. Network survey ended
If AT#CSURVF=2 the output will end with the string:
44. Network survey ended (Carrier: <NoARFCN> BCCh: <NoBCCh>)
The network survey information text lines are described in the Additional info
sections.
Parameters:
Name
Type
Default
Description
<s>
integer
-
starting channel, see #CSURV command.