Telit Wireless Solutions ME910G1 User Manual

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 322 of 1039 2021-09-23
Not Subject to NDA
3.4.6. AT#SIMDET - SIM Detection Mode
The command manages the SIM Detection mode.
[1] Telit Hardware Design Guide of the used module.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Common
profile
No
-
2
AT#SIMDET=<mode>
Set command simulates the SIM status or selects the automatic SIM
Detection status. This command is used: by modules providing the SIMIN
pin, dedicated or set through #SIMINCFG command; by modules without
SIMIN pin, forcing SIM presence or absence.
Refer to document [1] to have information on dedicated SIMIN pin.
Parameter:
Name
Type
Default
Description
<mode>
integer
2
the <mode> parameter can be used as
shown in Values section.
Values:
0
:
ignores dedicated SIMIN pin, and simulate the status
"SIM Not Inserted"
1
:
ignores dedicated SIMIN pin, and simulate the status
"SIM Inserted"
2
:
selects automatic SIM detection using dedicated
SIMIN Pin

Telit Wireless Solutions ME910G1 Specifications

General

Module Type	LTE Cat M1 / NB1 / NB2
Regions	Global
Form Factor	LGA
Operating Temperature	-40°C to +85°C
GNSS	GPS, GLONASS, BeiDou, Galileo
Category	Wireless Module
Data Rate (LTE Cat M1)	375 kbps (DL), 375 kbps (UL)
Storage Temperature	-40°C to +90°C
Interfaces	UART, I2C, GPIO, SPI, ADC
Weight	6 g
SIM	3V/1.8V
Certifications	GCF, CE, FCC, PTCRB
LTE Bands	B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B26/B28