Telit Wireless Solutions ME910G1 - AT+CLIR - Calling Line Identification Restriction

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 199 of 1039 2021-09-23
Not Subject to NDA
3.3.7. AT+CLIR - Calling Line Identification Restriction
The command manages the CLIR service.
3GPP TS 27.007
3GPP TS 22.081
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT+CLIR=[<n>]
Set command overrides the CLIR subscription when temporary mode is
provisioned as a default adjustment for all following outgoing calls. This
adjustment can be revoked by using the opposite command. This
command refers to CLIR service that allows a calling subscriber to enable
or disable the presentation of the Calling Line Identification to the called
party when originating a call.
Parameter:
Name
Type
Default
Description
<n>
integer
0
setting of CLIR service
Values:
0
:
CLIR facility according to CLIR service network status
1
:
CLIR facility active (CLI not sent)
2
:
CLIR facility not active (CLI sent)
This command sets the default behavior of the device in all
outgoing calls.