Telit Wireless Solutions ME910G1 - AT+CEDRXS - Edrx Setting

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 271 of 1039 2021-09-23
Not Subject to NDA
3.3.34. AT+CEDRXS - eDRX Setting
This command controls the setting of the UEs eDRX parameters.
3GPP TS 27.007
3GPP TS 24.008
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+CEDRXS=[<mode>[,<AcTtype>[,<Req_eDRX>]]]
Set command controls the setting of the UEs eDRX parameters. The
command controls whether the UE wants to apply eDRX or not, as well as
the requested eDRX value for each specified type of access technology.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
disable or enable the use of eDRX in
the UE. This parameter is applicable to
all specified types of access
technology, i.e. the most recent setting
of <mode> will take effect for all
specified values of <AcTtype>.
Values:
0
:
disable the use of eDRX
1
:
enable the use of eDRX
2
:
enable the use of eDRX and enable the
unsolicited result code, see Additional info.
3
:
disable the use of eDRX and discard all
parameters for eDRX or, if available, reset to the
manufacturer specific default values