ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 841 of 1039 2021-09-23
3.20.2. AT#CCIOTOPT - CIoT Optimization Configuration
This command controls CIoT EPS (Cellular Internet of Things, Evolved Packet System)
optimizations.
AT#CCIOTOPT=<bitmask>
The set command controls which CIoT EPS optimizations the UE indicates
as supported and preferred in the ATTACH REQUEST and TRACKING AREA
UPDATE REQUEST messages.
Parameter:
is used to store the mask in NVM for
subsequent use by protocol stack.
The <bitmask> value - formed by four hex
digit - is contained in two bytes.
The first nine bits, starting from the right,
are associated to the nine functions
described in the table shown in Additional
info.
The default <bitmask> value is 0137