Telit Wireless Solutions ME910G1 - AT#SSENDEXT - Send Data in Command Mode Extended

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 674 of 1039 2021-09-23
Not Subject to NDA
3.15.16. AT#SSENDEXT - Send Data in Command Mode extended
This command allows to send data through a connected socket including all possible
octets (from 0x00 to 0xFF).
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#SSENDEXT=<connId>,<bytesToSend>[,<Rai>]
Execution command permits, while the module is in command mode, to
send data through a connected socket including all possible octets (from
0x00 to 0xFF).
After entering AT#SSENDEXT=... command, and terminated the command
line with <CR>, the module returns the following four characters sequence
prompt, and waits for data to send:
<CR><LF><greater_than><space> (see IRA character set: 13, 10, 62, 32)
When <bytesToSend> bytes have been sent, operation is automatically
completed.
If data are successfully sent, the command returns OK. If data sending
fails for some reason, an error code is reported.
Parameters:
Name
Type
Default
Description
<connId>
integer
N/A
socket connection
identifier
Value:
1÷10
:
socket connection identifier
<bytesToSend>
integer
N/A
number of bytes to be
sent
Value: