Telit Wireless Solutions ME910G1 - Page 189

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 189 of 1039 2021-09-23
Not Subject to NDA
<lac>, <ci> and <AcT> network information is reported by URC only
if <mode>=2, and the module is registered on some network cell.
AT+CREG?
Read command returns the current value of <mode>, the registration
status <stat>, and the network information (<lac>, <ci> and <AcT>)
according to the used <mode> parameter value.
+CREG: <mode>,<stat>[,<lac>,<ci>[,<AcT>]]
<lac>, <ci>, and <AcT> network information is reported only if <mode>=2
and the module is registered on some network cell.
AT+CREG=?
Test command returns supported values for parameter <mode>.
Check the registration status of the module.
AT+CREG?
+CREG: 0,2
OK
The module is in network searching state
...
...
Check again module status
AT+CREG?
+CREG: 0,1
OK
The module is registered