Telit Wireless Solutions ME910G1 - Page 249

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 249 of 1039 2021-09-23
Not Subject to NDA
46
:
PDP context without TFT activated
47
:
multicast group membership timeout
48
:
retry on new cell begin (if MM cause failure) /
activation rejected BCM violation (if SM
cause failure)
50
:
PDP type IPV4 only allowed
51
:
PDP type IPV6 only allowed
52
:
single address bearers only allowed
63
:
retry on new cell end
81
:
invalid transaction identifier
95
:
semantically incorrect message
96
:
invalid mandatory information
97
:
MSG type non-existent or not implemented
98
:
MSG type not compatible with protocol state
99
:
IE non-existent or not implemented
100
:
conditional IE error
101
:
MSG not compatible with protocol state
111
:
protocol error unspecified
112
:
APN restriction value incompatible with
active PDP context
Telit recommends that the host controlling the modem defines
the proper retry/reboot scheme for reject causes 2, 7, 11, 14, 30,
33, 34, 38.