Telit Wireless Solutions ME910G1 - Page 263

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 263 of 1039 2021-09-23
Not Subject to NDA
Read command returns the current value of parameter <mode> in the
format:
+CEMODE: < mode >
The read command will return right values after set command, but
effectively the mode of operation changes after power cycle.
AT+CEMODE=?
Test command returns the supported range of values of parameters
<mode>.
Set EPS mode
AT+CEMODE=1
OK
Check EPS mode
AT+CEMODE?
+CEMODE: 1
OK