Telit Wireless Solutions ME910G1 - Page 357

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 357 of 1039 2021-09-23
Not Subject to NDA
actions initiated by the user, refer
to Additional info section.
If <mode>=2, the URC format depends on
the <cmdType> as described in the
Additional info sections. For <cmdType>,
and all other URC parameters refer to
#STGI command. The <mode> parameter
values are listed below.
Values:
0
:
disable SAT/USAT
1
:
enable SAT/USAT without #STN URC
2
:
enable SAT/USAT and extended #STN URC
3
:
enable SAT/USAT and reduced #STN URC
17
:
enable SAT/USAT without #STN URC and the
alphabet used
18
:
enable SAT/USAT, extended #STN URC, and the
alphabet used
19
:
enable SAT/USAT, reduced #STN URC, and the
alphabet used
33
:
enable SAT/USAT without #STN URC and the UCS2
alphabet used
34
:
enable SAT/USAT, extended #STN URC, and the
UCS2 alphabet used
35
:
enable SAT/USAT, reduced #STN URC, and the
UCS2 alphabet used
<timeout>
integer
2
When an ongoing proactive command,
requiring a user response, is not
answered before <timeout> minutes, it is
automatically aborted. In this case, the
terminal response from the module is
either "ME currently unable to process
command" or, if applicable, "No response