Telit Wireless Solutions ME910G1 - Page 401

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 401 of 1039 2021-09-23
Not Subject to NDA
2
:
if a status report is stored, then the unsolicited result
code, described in Additional info section, is sent.
<bfr>
integer
0
buffered result codes
handling method
Values:
0
:
TA buffer of unsolicited result codes defined within
this command is flushed to the TE when <mode>=1..3
is entered (OK response shall be given before flushing
the codes)
1
:
TA buffer of unsolicited result codes defined within
this command is cleared when <mode>=1..3 is
entered.
Additional info:
<mt>=1:
+CMTI: <mems>,<index>
<mt>=2:
PDU mode
+CMT: <alpha>,<length><CR><LF><PDU>
TEXT mode
+CMT:<oa>,<alpha>,<scts> [,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length>] <C
R><LF> <data>
The parameters written in italics will be present depending on +CSDH last
setting.
Class 2 messages and messages in the message waiting indication group
(stored message) result in indication as defined in <mt>=1.