Telit Wireless Solutions ME910G1 - Page 492

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 492 of 1039 2021-09-23
Not Subject to NDA
#NITZ: <val>,<mode>
AT#NITZ=?
Test command returns supported values of parameters <val> and <mode>.
The command parameters are stored in two different profiles:
18. <val> must be valid for all AT instances, so its value is entered in
Common profile (extended section).
19. <mode> must be valid only for the AT instance where it has been set,
so its value is entered in Specific profile (extended section).
Use the #W[<n>] command to store the updated profiles in NVM.