Telit Wireless Solutions ME910G1 - Page 539

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 539 of 1039 2021-09-23
Not Subject to NDA
0
:
no effect
Additional info:
Format of the message printed out by the execution command:
#ADC:<value>
Name
Type
Default
Description
<adc>
integer
-
pin voltage expressed in mV.
The command returns the last valid measure.
AT#ADC?
Read command reports all pins input voltage in the format:
#ADC:<value>[<CR><LF>#ADC:<value>[...]]
AT#ADC=?
Test command reports the supported range of values of the command
parameters <adc>, <mode> and <dir>.