Telit Wireless Solutions ME910G1 - Page 553

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 553 of 1039 2021-09-23
Not Subject to NDA
command. This parameter is
needed and required only if
<action> 2 or 3 is enabled.
To have hardware information
about GPIO refer to document [1].
Unsolicited fields:
Name
Type
Description
<level>
integer
threshold level
Values:
-2
:
extreme low zone, see #TEMPCFG
command
-1
:
operate low zone, see #TEMPCFG command
0
:
operate normal zone, see #TEMPCFG
command
1
:
operate up zone, see #TEMPCFG command
2
:
extreme up zone, see #TEMPCFG command
<value>
integer
current temperature expressed in Celsius degrees.
#TEMPCFG command sets the thresholds levels. See there, also
the description of the thermal mitigation configuration and its
mechanism.
Last <action> and <GPIO> settings are saved in the file system.
AT#TEMPMON?
Read command reports the current parameter settings for the command
in the format:
#TEMPMON: <urcMode>,<action>[,<hystTime> [,<GPIO>]]