Telit Wireless Solutions ME910G1 - Page 564

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 564 of 1039 2021-09-23
Not Subject to NDA
AT#ENHRST?
Read command reports the current parameter settings in the following
format:
#EHNRST: <mode>[,<delay>,<remainingTime>]
Additional info:
Read command parameter for <mode> =1 or 2.
Name
Type
Default
Description
<remainingTime>
integer
-
time in minutes remaining
before next reset
AT#ENHRST=?
Test command reports supported range of values for parameters <mode>
and <delay>.
Example of #ENHRST usage and expected unit behavior.
•
AT#ENHRST=1,60
...
Module reboots after 60 minutes
•
AT#ENHRST=1,0
Module reboots immediately
•
AT#ENHRST=2,40
...
Module reboots after 40 minutes, and after every following power on,
it will continue to reboot always after 40 minutes.