Telit Wireless Solutions ME910G1 - Page 819

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 819 of 1039 2021-09-23
Not Subject to NDA
#SSLRECV: NumByteRead
...(Data read)...
OK
If no data are received, the device responds:
#SSLRECV: 0
TIMEOUT
OK
If the remote host closes the connection, the device responds:
#SSLRECV: 0
DISCONNECTED
OK
If secure socket is not enabled using AT#SSLEN, only test requests
can be made.
If timeout is not set for SSL connection, the default timeout value,
set through AT#SSLCFG, is used.
Before receiving data from the SSL connection, it has to be
established using AT#SSLD.
AT#SSLRECV=?
The test command returns the ranges of the parameters values in the
form:
#SSLRECV: (1),(1-1000),(10-5000)