Telit Wireless Solutions ME910G1 - Page 975

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 975 of 1039 2021-09-23
Not Subject to NDA
<nsat>
integer
N/A
total number of satellites in use
(referred to GGA sentence)
Value:
0÷12
:
total number of satellites in use
AT$GPSACP?
Read command has the same behavior as the Execution command.
AT$GPSACP=?
Test command returns the OK result code.
AT$GPSP?
$GPSP: 0
When the module is down there is no acquired position:
AT$GPSACP
$GPSACP: ,,,,,0,,,,,
OK
AT$GPSP=1
OK
Until first fix is received the command will display this:
AT$GPSACP
$GPSACP: ,,,,,1,,,,,
Once fix has been received the command will display actual GPS time and
position:
OK
AT$GPSACP
$GPSACP:
091635.000,3913.6952N,00904.1505E,0.7,17.9,3,0.0,0.0,0.0,290920,10
OK