Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 1002 of 1039 2021-09-23
Not Subject to NDA
Mobile Broadband
3.26.1. Ethernet Control Mode (ECM)
3.26.1.1. AT#ECM - Ethernet Control Model Setup
This command sets up an Ethernet Control Model (ECM) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ECM=<Cid>,<Did>
Parameters:
Name
Type
Default
Description
<Cid>
integer
-
context id that will be used by ECM. Refer to
test command to know the supported range
of values.
<Did>
integer
-
device id, currently limited to 0 (only one
device)
To enable the ECM session configuration the module must be
rebooted.
To activate an ECM session a compatible USB configuration has to
be set; for details refer to the description of #USBCFG.
AT#ECM?
Read command returns the session state in the following format:
# ECM: <Did>,<State>
OK
Additional info:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English