Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 672 of 1039 2021-09-23
Not Subject to NDA
3.15.15. AT#SSEND - Send Data in Command Mode
This command is used to send data through a connected socket.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#SSEND=<connId>[,<Rai>]
Execution command permits, while the module is in command mode, to
send data through a connected socket.
After entering AT#SSEND=... command, and terminated the command line
with <CR>, the module returns the following four characters sequence
prompt, and waits for data to send:
<CR><LF><greater_than><space> (see IRA character set: 13, 10, 62, 32)
To send the entered data, enter Ctrl-Z char (0x1A hex); to abort the
operation enter ESC char (0x1B hex).
If data are successfully sent, the command returns OK. If data sending
fails for some reason, an error code is reported.
Parameters:
Name
Type
Default
Description
<connId>
integer
N/A
Selection on which Socket
connection identifier send data.
Value:
1÷10
:
Socket connection identifier supported
<Rai>
integer
1
RAI (Release Assistance
Indication) configuration
Values:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English