Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 340 of 1039 2021-09-23
Not Subject to NDA
3.4.14. AT+CGLA - Generic UICC Logical Channel Access
This command is used to control the currently selected UICC on the TE.
[1] 3GPP TS 11.11
[2] 3GPP TS 31.101
[3] 3GPP TS 31.102
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CGLA=<sessionId>,<length>,<command>
Set command transmits to the MT the <command> it then shall send as it
is to the selected UICC. In the same manner the UICC <response> shall be
sent back by the MT to the TA as it is. This command allows a direct control
of the currently selected UICC by a distant application on the TE. The TE
shall then take care of processing the received UICC information. The
response of the command is in the format:
+CGLA: <length>,<response>
Error case:
+CME ERROR: <err>
The response messages parameters are described in the Additional info
section.
Parameters:
Name
Type
Default
Description
<sessionId>
integer
-
this parameter is the identifier of the
session to be used in order to send the
APDU commands to the UICC. It is
mandatory to send commands to the

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English