ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 175 of 1039 2021-09-23
3.2.5.2. ATA - Answer Incoming call
Execution command is used to answer to an incoming call if automatic answer is
disabled.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
This command must be the last in the command line and must be
followed immediately by a <CR> character.
Warning: the "Not required" information contained in the "SIM
Presence" field of the table, placed above the command syntax,
must be replaced with "Required".
Modules supporting the command
To Next Page
Loading...
Need help?
General
