Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 639 of 1039 2021-09-23
Not Subject to NDA
3.15.3. AT#SGACTCFG - PDP Automatic Context Activation-Reactivation
This command configures the automatic activation/reactivation of the specified PDP
context
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SGACTCFG=<cid>,<retry>[,<delay>[,<urcmode>]]
Set command enables/disables the automatic activation/reactivation of the
specified PDP context, sets the maximum number of attempts and the
delay between an attempt and the next one. The context is automatically
activated after every PS attach or after a network PDP context deactivation
if at least one IPEasy socket is configured for that context, see #SCFG
command.
Parameters:
Name
Type
Default
Description
<cid>
integer
-
PDP context identifier. To know the
range see +CGDCONT command.
<retry>
integer
0
specifies the maximum number of
context activation attempts in case of
activation failure.
0 disables the automatic
activation/reactivation of the context. It
is the default value if the set command
is not used, see Example section.
Value:
1÷15
:
number of attempts.
<delay>
integer
180
specifies the delay in seconds between
an attempt and the next one.
180 is the default value if the set
command is not used, see Example
section.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English