Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 683 of 1039 2021-09-23
Not Subject to NDA
3.15.19. AT#SSENDUDPEXT - Send UDP Data to a Specific Remote Host EXTENDED
This command permits, while the module is in command mode, to send data over UDP
to a specific remote host including all possible octets (from 0x00 to 0xFF)
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT#SSENDUDPEXT=<connId>,<bytestosend>,<remoteIP>,<remotePort>[,<Rai>]
Set command permits, while the module is in command mode, to send data
over UDP to a specific remote host including all possible octets (from 0x00 to
0xFF).
As indicated about #SSENDUDP, UDP socket has to be previously opened
through #SLUDP / #SA, then we are able to send data to different remote
hosts.
Like #SSENDEXT, the device responds with the prompt '> ' and waits for the
data to send, operation is automatically completed when <bytestosend> have
been sent.
Parameters:
Name
Type
Default
Description
<connId>
integer
N/A
socket connection identifier
Value:
1÷10
:
identifier number
<bytestosend>
integer
N/A
bytes to be sent
Value:
1÷1500
:
number of bytes to be sent
<remoteIP>
string
-
IP address of the remote host in
dotted decimal notation
("xxx.xxx.xxx.xxx")
<remotePort>
integer
N/A
remote host port

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English