Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 631 of 1039 2021-09-23
Not Subject to NDA
3.14.15. AT+CSODCP - Sending of Originating Data Via the Control Plane
The set command is used by the TE to transmit data over control plane to network via
MT. Context identifier <cid> is used to link the data to particular context.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CSODCP=<cid>,<cpdataLength>,<cpdata>,<RAI>[,<typeOfUserData>]
Parameters:
Name
Type
Default
Description
<cid>
integer
-
specifies a particular PDP
context or EPS bearer context
definition. The <cid> parameter is
local to the TE-MT interface and
identifies the PDP or EPS bearer
contexts which have been setup
via AT command (see the
+CGDCONT and +CGDSCONT
commands)
<cpdataLength>
integer
-
indicates the number of octets of
the <cpdata> information
element. When there is no data to
transmit, the value shall be set to
zero.
<cpdata>
string
-
is a string of octets. Contains the
user data container contents.
When there is no data to
transmit, the <cpdata> shall be
an empty string (""). This
parameter shall not be subject to
conventional character
conversion as per +CSCS. The
coding format of the user data
container and the maximum

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English